Who uses what auger oil?

[FirstIce]

Do most of you run the auger name brand 40:1? Anyone using the Amsoil Saber 100:1?

[Nilsfisher]

I use the stihl HP Ultra oil. mixed 50:1. that way i use the same gas as my chain saw and its easier to keep it fresh. never have issues. 

[Hawg]

You'll never look back, Sabre 100-1. I actually do about 80 -1. Better starting and almost zero exhaust. 

[Naturboy]

I was told a few years ago by the people at Strike Master to run  50:1 to keep oil from running out of the muffler after the break in period. I use the same oil I use in my boat motor which I also run 50:1.

[401TE]

Amsoil for me.  More like 80:1. 

[Bass Thumb]

My old StrikeMaster Lazer that I may sell was spitting some exhaust splatters with a 50:1 ratio, even after a carburetor tune-up. The Amsoil Saber 100:1 helped a lot with that, and it started with just a pull or two. 

[MNice]

amsoil sabre.  64:1.  goofy ratio I know, but i use 2oz per gallon of non oxy gas, just easy to measure and a little more piece of mind.  I use this in all my 2 strokes.

[Nordern]

I have also been going with the Amsoil Saber at around 80:1.  I let the auger warm up as I set the wheelhouse up and there is minimal fumes when I drill the hole.  I guess the trick is to let the auger warm up first.

[fishingstar]

I have been using Amsoil Saber at 80:1 for many years. I use the same gas in all my small two stroke motors