- 0
-
Your Responses - Share & Have Fun :)
-
-
By Wanderer · Posted
@Mike89 iffen yer not gonna pick a date, can I do it in yer name? 😜 -
By JerkinLips · Posted
Table is updated below. Opening day is likely in jeopardy. Lots of good dates available for those sitting on the sideline. -
By leech~~ · Posted
That's ok, got the Bear hunting out of my system years ago. Still have some good spots on the GPS up in the Arrow head! Did love me some good greasy bear roasts though! 😋 -
By smurfy · Posted
Info is out. Got till may 2nd to apply. Kid and I have 6 preference it's so should be a good chance. No leech I aint telling ya where or you'll follow me around. 🤫🤣 -
By Brianf. · Posted
Yes, I'm on the West End. No crappies yet, but I caught a couple of Cisco's and some perch this morning. Been dealing with chores at the cabin since 10 AM, so not much fishing. -
-
By CigarGuy · Posted
Hard to tell exactly how much snow the way the wind was blowing it around, close to that I'll bet! 3 sleds went by earlier. Brian, are you on the west end? Did you fish? Catch any crappies? -
By Brianf. · Posted
I was on the lake this morning. There is still a lot of ice. I went down to the housing on my auger a couple of times. I'm not sure how much snow we got yesterday and last night but it looks like around 7 to 8 inches at least. -
-
Question
Whoaru99
I've always seen some sort of washer between the axle/spindle nut and the wheel bearing. Tore into one this evening that didn't have a washer. The axle/spindle is not slotted for a keyed washer, so will any sort of washer of appropriate size be fine there, or is it supposed to be a hardened or some other type of special washer?
Edited by Whoaru990 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.