-
Your Responses - Share & Have Fun :)
-
By leech~~ · Posted
Haydays can be fun but some times a picker nightmare to get in and out of. I like the Outlaw grass drag and swap meet in Princeton, MN a few weeks before Haydays. If you don't find it there you can always then check Haydays. I've found must everything I ever needed at the Outlaws swap! -
-
By smurfy · Posted
Oh boy, 🤔 2 troublemakers in the same town at once!🫢 where was deertracker when ya need him!🤔🤣 -
By Kettle · Posted
Make sure the unit is firmly in the cradle. Sometimes it seems in place and a loose connection will occur with sporadic power. The other thing is, if he has a micro USB map chip in, remove it. If it's corroded Sometimes these units will shut off in attempt to not cause electrical harm -
By Mike89 · Posted
they have good food there!! I'm about 11 miles north from the freeway -
By leech~~ · Posted
Went to Angelina's for lunch. 😋 When we went through Osakis I told my wife a guy name Mike on the forum lives around here somewhere? 😆 -
By JerkinLips · Posted
I'll put new plugs on the top of my list; cheap fix. One of the plugs had the threads worn off on the cap on top and it stuck in the rubber cap. Thought this may have been part of the problem but a new (used plug) with a tip cap didn't change the issue. The change in one plug is why I have mixed plugs in the picture. Lots of shopping to do at Haydays next fall - new belt, plugs, track, ski spindles/ bushing, clutch puller for a start. -
-
By leech~~ · Posted
Wow. Still looks like winter up there! I was in the Alex, area yesterday and most of the lakes were almost ice free. -
By CigarGuy · Posted
Went out this evening for a couple hours. Three of us only caught 4 crappies, small perch and a small bass. Ice is getting a little soft, but still 22" and tight to the shore where we were. Going out later tomorrow, caught more a dusk last time out.
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.