Guests - If You want access to member only forums on FM. You will gain access only when you Sign-in or Sign-Up on Fishing Minnesota.

It's easy - LOOK UPPER right menu.

Sign in to follow this  
Followers 0
bblanski

Where to buy a used Merc 115

10 posts in this topic

Mine went bad, where is a good reliable place to buy one. Mine was a '81 so somewhere in that year, I could go up to a 150 if the $ is right. Thanks

Share this post


Link to post
Share on other sites

I would give Val a call and see what he has on hand. He has much inventory and it would be worth the call.

http://www.kvesurplus.com

Share this post


Link to post
Share on other sites

I tried him already and he has nothing. frown.gif

Share this post


Link to post
Share on other sites

Craiglist, Boat trader magizines, All Marina's in your area.

The Sunday paper want ads "tribune".

What is your price point?

Do you need the controls, tilt and trim?????

Share this post


Link to post
Share on other sites

Quote:

Craiglist, Boat trader magizines, All Marina's in your area.

The Sunday paper want ads "tribune".

What is your price point?

Been looking thru all that stuff, If I go with the merc I have the controls and tilt and trim. I am considering a rebuilt for around $2500, just looking for the best deal.

Do you need the controls, tilt and trim?????


Share this post


Link to post
Share on other sites

you could try twin city marine or outboard in shakopee on canterbury rd off 169

Share this post


Link to post
Share on other sites

Quote:

you could try twin city marine or outboard in shakopee on canterbury rd off 169


I tried there also, thanks. I have a couple places that have some rebuilt. I just wanna make sure I get something that will last.

Share this post


Link to post
Share on other sites

I seriously doubt you can get anything for $ 150.00. I am sure you meant $ 1,500.00

This time of the year is really tough to find motors.

Share this post


Link to post
Share on other sites

Valv, I think he means he can go up to 150hp if the price is right.

Share this post


Link to post
Share on other sites

Quote:

Valv, I think he means he can go up to 150hp if the price is right.


Yes I did, but I ended up finding a old boat with a '94 115 Mariner and a bunch of other goodies for a real good price. If anyone is in need of an older boat and trailer I will have one for cheap(almost free) when I am done.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  
Followers 0



  • Posts

    • ZachD
      I guess I will have to call the dnr about the couple spots I am in question of. Ones a darn and you can easily pick them off all day almost year round
    • Stick in Mud
      Thanks for the great report.  We fished up there all last week, and we found shiners to be the only bait we *couldn't* get bites on. Very, very strange, but by far our best bite was on crawlers.  I think our total was something like 8 fish on shiners and 80 or 90 on crawlers (between two boats).  We didn't start fishing with crawlers until Thursday, either, so all those fish came on our last two days, with the windier Thursday being best.
    • Dale S
      Thanks guys for the informative replies. Can you also comment on the walleye limits?
    • noska
      Hey Barefoot on the main lake or current areas? 
    • jkrash
      a tournament-record 10-pound, 2-ounce beauty was big fish and A record 110 boats fished this year’s tourney, held out of the marina at Fortune Bay Resort Casino. 492 walleye, another tournament record, were weighed and released at this catch-and-release event.
    • Bowfin
      My daughter is shooting my 12 gauge 870 Wingmaster really good. Im looking for a nice looking, nice shooting and dependable pump shotgun for her at a decent price. I'm not liking the newer 870 Wingmasters as much as I did when I bought mine 30 years ago. I recently saw some Weatherby PA08s. Very nice looking gun which rival the looks of old Wingmasters with walnut stock, deep checkering, fairly light for $350 new. Reviews I see from 2011-2014 have me concerned a bit about hard trigger pull and shells sometimes not ejecting. Anyone have any experience or knowledge about these Weatherby pumps? If there were issues, you would think Weatherby would have fixed them by now.
    • jb426
      I did this a while back.  If you have basic carpentry skills you can do it for under $200. Here's what I did.   Get 2x8 treated board.  Cut to length of back bench.  Attach a swivel seat to board then attach board to back bench using screws and glue.   Buy two sheets of 4x8 3/4" sheeting that's rated for exterior and a gallon of deck stain.  Stain said sheets.  Cut out one for floor and one for casting deck up front (i used the front bench with a little bracing in between).  Use left over 2x8 for bracing casting deck.  You will also need one 2x4 treated board for bracing of the floor.  Install casting seat up front.  Looks good and is cheap and easy.  I used cedar stain and bought cedar colored treated lumber.  If I remember correctly I cut out the middle bench.   Only problem was it added a lot of weight so had to upgrade to 15 horse.  Sold it  a couple of years later for a $100 profit.  Just an idea.  
    • Walleye #1
        Walleyes on Leech Lake found themselves spread out but actively feeding on shiners.  A Jig and shiner or a plastic and lindy rigs with shiners and leeches were the go to presentations during the course of the week.  Somedays walleyes were wanting it dragged along which is where lindy rigs worked well and other days snapping or twitching a jig and minnow was the ticket.  So being diverse in your presentations, changing up colors and cadences, and getting away from the crowds is the ticket.     West End - Fish were found on West Goose Flats, Star Point, Grand Vu Flats, Duck Point, Pine Point, Stoney, and on some of the breaklines in Traders Bay.  Depending on the day depths changed, but it seemed the best bite was in 8-14 feet of water.  Find the shiners and you found walleyes closeby!     East End/Main Lake - Main Lake Rocks are still producing a large quantity of fish in the 20-26” protected slot, with some keepers mixed in.  Annex, Submarine, Five Mile, Pelican Island, and Rogers Point all had decent bites. Fish were typically found in that 8-12ft range on this part of the lake and finding areas with sand and boulders was the key.  Portage Bay also reported a good bite up near Federal Dam.  Look for emergent cabbage in Portage, especially on those bright and sunny days where those walleyes will look to find cover.  Pitching a jig and minnow or jig and plastic for these Leech Lake Walleyes in the cabbage is fun way to catch them.     Jumbo Perch are also showing up with the walleyes, but often times will be shallower.  Found some of our best perch bites in 6-10ft of water, with some really nice jumbos mixed in.     Jason Freed Leisure Outdoor Adventures Fishing Guide Service
    • HugeHogChaser
       Any boat restorers here in the twin cities area?  Looking to get some information and possibly a quote on a 12 foot aluminum boat. Would like benches re-done with carpeting, and possible floor work. Thanks in advance, I appreciate it!
    • HugeHogChaser
      Good evening,   i recently inherited a 12 foot aluminum boat, and I would like to re-do the interior. (Add carpet to the benches, possibly add marine grade plywood to the floor and carpet the floor as well.)   does anybody have any experience doing this, or recommend anybody that is good with this type of thing?    Trying to figure out if it's worth it to pay someone to do it, or try and figure out how to do it myself with no experience.    Anyways, thanks in advance!