Guests - If You want access to member only forums on FM. You will gain access only when you Sign-in or Sign-Up on Fishing Minnesota.

It's easy - LOOK UPPER right menu.

Sign in to follow this  
Followers 0
Harp

Two transducers / depth finders problems?

2 posts in this topic

I see dual finders on boats but???I currently have a Uniden in dash digital depth readout just to the lower unit out of trouble and I will be installing a Hummingbird Parina 15 fish finder and I only have enough transducer cable to put them close or next to each other.I looked at their frequecency and it is the same I think? Hummingbird on single beam MHZ 200 with 83 MHZ dual Uniden is 200 MHZ is that the number to be concerned about? so if I put an off/on toggle to the Uniden to shut it down when I run the Hummingbird will that work? or am I looking for problems? I don't want to butcher up the boat then have to move stuff around after the fact.

HARP

Share this post


Link to post
Share on other sites

Hi,

There will be no doubt that if you put two transducers close together that carry the same freqency you will get interference. if it is easy enough to put a switch on your uniden, I would suggest that.

Steve

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  
Followers 0



  • Posts

    • eyeguy 54
      we should have ll given you one    
    • Jim Uran
      Sorry, been offline for a while. Yes you can STILL drive out there if you're brave. I've seen people do it last night and they are probably still driving out there today. I'm going to go check in a bit, fishing has been pretty stellar as of late. 
    • osok
      Been out of town for the past week-ish, how are the local ice conditions, are people still driving out (safely) on Fish, Boulder..?
    • leech~~
        Just ribbing yea a bit.  Because it was just a little bit bigger then all the ones I brought home. Zero!  
    • monstermoose78
      That poor crappie will feed my grandma just fine @leech~~ I can't help it was not smaller or bigger. Well I could have tossed it back but I do that most of the time