I can see it in the plastic bowl, but am not sure how to open it with out breaking something or if there is pressure waiting to spray gas all over I was gonna ask at the dealer tonite but spaced it out Thanks again for all the help..
Was out for a while on the Partridge River this afternoon, didn't have any minnows, managed one 13" crappie on Gulp waxes. But, the old Strikemaster almost bottomed out-close to 30" of ice.
I don't know what your Helix 7 requires in the manual, but a quick look would figure out if that 3amp is too small.
Definitely wire your sonar to the motor battery using the correct gauge wire and fuse. If you connect it to another battery, it should be a stand-alone. Connecting to the trolling motor battery will generate interference.
I've done cheeks quite a few times and they are always good. They take only a few seconds to carve out. I like to get the most out of the things I kill to eat, so I'm not afraid to pull them out of smaller ones.
I'm glad to see that so many people picked up a new tip. That's the point of congregating on these forums. I wonder how many non-registered folks will read this and learn something new.
With the snow cover completely gone and lots of standing water, 60s in the forecast, with plenty of sunny days next week, and a good chance of rain mid-week; this may be my last weekend on the ice, South of Hwy 210 anyway . Fish have really been on the chew
hey guys..i installed the helix 7. took it out the other day. it keeps randomly shutting down, with the motor off it will stay on no problem. Heres where i think i f'd up. i used the same 3 amp fuse harness from the old sonar that came with the boat, the old hb depth only kind. its wired right to the ignition wire. i used the correct gauge wire where i needed it. im guessing its not getting enough juice?
also if i wired it direct to a separate battery, how do i go about hooking up and on board charger? or would i be ok just wiring direct to the battery that runs the motor?
thanks for any advice.
those musky lures look so bad ass! nice work !!
I can see it in the plastic bowl, but am not sure how to open it with out breaking something or if there is pressure waiting to spray gas all over
I was gonna ask at the dealer tonite but spaced it out
Thanks again for all the help..
TOMMY T from Blaine
Share this post
Link to post
Share on other sites