- 0
By TrueNorth · Posted
By BWpineisland · Posted
By Raven77 · Posted
By Orlip · Posted
By Mtnman · Posted
By Muskies · Posted
By Coleman · Posted
By Raven77 · Posted
By using this site, you agree to our Terms of Use and Privacy Policy. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.
Question
MinnesotaMuskie
I have an old Lund, 1980 or so, I use in Canada. Well we over loaded it on the way up and bounced a roller on the trailer to a bad spot and cracked the aluminum near the rear of the boat.
I cannot find a wleder to fix the boat unless I pull the motor and flip it over:)
The crack is about 4 inches long and located where the bottom of the hull turns up to the side of the boat.
Any suggestions??
Link to comment
Share on other sites
1 answer to this question
Recommended Posts