• GUESTS

    If You  want access  to member only forums on FM, You will need to Sign-in or  Sign-Up now .

    This box will disappear once you are signed in as a member.

  • Join In - We Share Fishing Reports & Outdoor Information Here

     
      You know what we all love...

      The same things you do!!!! Share what you love & enjoy in the outdoors as well as thank those whose posts you 'appreciate.'

      Have Fun!!!

  • ×   Pasted as rich text.   Restore formatting

      Only 75 emoji are allowed.

    ×   Your link has been automatically embedded.   Display as a link instead

    ×   Your previous content has been restored.   Clear editor

    ×   You cannot paste images directly. Upload or insert images from URL.



  • Similar Content

    • Sunset Lodge
      By Sunset Lodge
      Hello from the NW Angle!
       
      On the Minnesota side, spinners and crawler harnesses are still the preferred method of walleye fishing, with the hot colors being pink/gold, orange/gold and orange/chartreuse. Walleye are being caught off of structure scattered in the mud between 20 and 30 feet. Down riggers and deep running crank baits have also been productive.
       
      Canadian walleye are being caught in channels off of islands and along reefs in 18 to 25 feet of water. Both bottom bouncers with a crawler harness and a jig with minnow or shiner have both been successful in Canadian waters.
       
      Musky fishing success has increased in the past week. Fish are being caught on crank baits and blade baits. With water temps in the low 70’s muskies are favoring rocks near weeds. 
       
      Our very own, Travis Palmquist, released a 54.5" musky yesterday!
       
      Fall is a great time for trophy fishing!
       
      We hope to see you soon,
       
      Sunset Lodge





    • Sunset Lodge
      By Sunset Lodge
      Hello from the NW Angle!
       
      In Minnesota, walleye are still scattered through out the main lake basin. Night crawlers on a spinner remains most effective.  Make drifts/passes parallel but off of structure including islands and reef break lines in 24-30 feet.  Hot colors have been gold/pink, gold/orange or hammered gold.  Deep running crank baits are another good option, often producing bigger fish and large northern pike. 
       
      On the Canadian side of the lake, fish can be schooled on humps and reefs.  Once located, fish these areas with a jig and minnow or shiner.  Pulling spinners in 25-30 feet of water is most productive in covering ground to locate feeding and roaming walleye.  Muskie action continues to improve through out the week.  Multiple big fish were caught on Sunday with many others boated as well as, a lot of lookers.  As activity levels rise, blade baits have been triggering positive reactions. Water temperatures remain consistent in the low 70's. 
       
      Until next week,
       
      Sunset Lodge






    • Sunset Lodge
      By Sunset Lodge
      Hello from the NW Angle!
      Water temps are consitently in the mid to high 70’s.
      Walleye in Minnesota can be caught on reefs with a jig and minnow. More productive methods currently are bottom bouncers and crank-baits in 24-28 feet of water.  Covering a lot of ground is key when the fish arent schooled together.  We have had many 40”+ Pike caught while trolling, reports of large Muskie also.
      Candian walleye are spread out as well, making bottom bouncing and deep cranks the ticket to success. Fish mud bottomed areas deeper than 25ft for best results. Many nice jumbo perch limits have been coming in recently. They are biting on a jig and fathead and are concentrated at 28-30ft.
      Until next week,
      Sunset Lodge
































    • Sunset Lodge
      By Sunset Lodge
      Hello from the NW Angle!

      Water temperatures are starting in the low 70’s in the morning, reaching mid to upper 70’s in the evening.

      Minnesota walleye action can be hot running deep diving crank-baits straight, down rigging or lead core. Soft bottom areas can also be worked with spinners and a night crawler.  Fish have been favoring gold on bright days and orange, chartreus or pink in low light.  Many larger northern pike this last week in the boat via crank-baits just outside of rock reefs and points.

      Canadian walleye fishing has been more productive away from reefs and points in soft bottomed areas. The best method is to pull a spinner to find concentrations along the bottom and switch to jigging to fill out limits.

      Musky attitude in Canada varies day to day. Plenty of fish are still being caught in shallow weeds including a couple of 50+ giants this past week.  Fish are also being caught in more traditional mid-summer spots such as rock reefs and points.  The most productive baits this week were crane baits or other flat baits, buck tails and top waters. 

      Until next week,
      Sunset Lodge
       













    • Sunset Lodge
      By Sunset Lodge
      Hello from Sunset Lodge!

      In Minnesota, walleyes and pike have been found using crank-baits on the south side of Oak Island.  Walleye have also been caught pulling spinners in 26-30 feet using gold and green.
       
      In Ontario, walleye have been very active using pink and orange jigs on the breaks of reefs or casting shallow crank-baits in 8-12 feet by rocky shoreline points.  A good mixed bag of smallmouth and pike have been found with the walleye as well.
       
      Musky fishing has really picked up with lots of fish over 40+ inches.  Fishing sand and weedy bays near rock reefs have produced well using buck-tails, small crank-baits and top-water baits. 

      Until next week!
      Sunset Lodge

  • Your Responses - Share & Have Fun :)

    • yoppdk
      I'm pretty sure there is a setting on your Hummer that lets you set where (voltage level) you want to get the "low battery" warning or dropout. At least mine does ... and I temporarily reset it once to keep it from dropping out each time I started the outboard. Of course I wouldn't advise that for a long-term fix as you might go to start the engine one time and get nothing but clicks. Is it possible that setting got changed at one time and maybe it's set too high?
    • chaffmj
      Well I got skunked on my first ever attempt to fish muskies. It was still a lot of fun and I will try it again!
    • Rick
      DNR urges people to use caution when operating farm equipment Exceptionally dry conditions in the northwest part of the state have contributed to several small fires over the past week. To prevent a possible wildfire, the Department of Natural Resources urges extreme caution when using farm equipment right now.  To reduce the chances of starting a wildfire when working in the field, follow these steps: Make sure machinery is well maintained and working properly to prevent overheating and the formation of sparks. When cutting or mowing, be aware of rocks that may cause sparks if struck by mower blades. Check that all fire extinguishers are appropriate for the size of the machinery, are fully charged, and are easily accessible. Carry an ABC rated fire extinguisher – it can be used for electrical and petroleum-based fires originating on the tractor and for vegetative fires. Check and remove combustible vegetation from motors, exhausts, ledges and brackets several times a day. Remove debris from the surface of the baler using a portable gas-powered leaf blower. Keep hay in groups of 10 bales or fewer and at least 100 feet away from structures or other ignition sources. Firebreaks – 30 feet of mowed grass, bare ground, or rock between bale groups – will help prevent fire from extending to additional bales. Frequently check to see if stored hay is hot or has internal fire (noted by a caramel or strong burning odor, visible vapor or smoke, strong musty smell, or all of the above). Do not move overheated or smoldering hay. Immediately call 911 if fire occurs and provide clear directions to your location. Check the weather – avoid running equipment on days with warm temperatures, high winds, and low humidity. Plan your day – take advantage of mornings and evenings that tend to have calmer winds, cooler temperatures, and higher humidity. Find more information about fire danger at mndnr.gov/burnrestrictions. ### Discuss below - to view set the hook here.
    • mrpike1973
      From what I'm hearing I believe I will just keep my K-Drill. I have no doubts whatsoever that Nils is a great product and Frank does awesome work on the blades. Many of my friends have used his services before. I drill a lot and almost always on dirty wind swept ice last year was terrible on the lakes I was on. 2 sets of blades for me last year first set got dull around January then replaced to the second set at the end of the year. I did call K Drill today they said that's normal for the usage I do. No cause for alarm at all. So I'm always looking for the grass is greener on the other side type person. No hurt feelings here fellas both are good augers and I will not say bad things about them just thought I was missing the boat but as someone said does it really matter if you get the hole drilled 2 seconds faster? It matters how many fish you pull up that hole😁
    • BobT
      Here's a thought that just occurred to me. I was having some similar issues with my sonar unit. While troubleshooting noise feedback from my trolling motor, one thing I tried was to add a ferrite core filter on the power cable to my HB 596c. Now that I think about it, I have not had a problem with my HB shutting down on starting my outboard since I added the filter. It's possible the ferrite core is attenuating the voltage fluctuation just enough.    Got the clamp-on filter online for less than $5.00. Something like this one from ebay. You need to get the right size to fit your HBs power cable. Mine was 1/4".   Inexpensive thing to try.
    • leech~~
      So there is Trout in there as well?  Where is this Holy Buckets Lake?  😯
    • BobT
      Now, I'm puzzled. Both units should therefore be experiencing the same brownout conditions when you start your outboard. I wonder if a surge suppressor might be helpful? Is the bow mount unit a newer unit and if so, maybe it has updated technology that is less susceptible to the voltage drop. I'm just thinking out loud now. 
    • Rick G
      Wow, nice gill😁
    • Fish Head
      Yes they are. 
    • Rick G
      Mr Pike, if you are going through blades that fast on the k-drill, you will certainly dull them out just as fast or faster on a Nils. The Ripper style blades that come on the K are about as good as it gets as far as durability goes.