Jump to content
  • GUESTS

    If You  want access  to member only forums on FM, You will need to Sign-in or  Sign-Up now .

    This box will disappear once you are signed in as a member.

Buddy Heater Travel Question


wookie24

Recommended Posts

I'm starting a new mod on my porty, and was wondering if anyone has had any issues keeping there buddy heaters in the sled while pulling behind a wheeler/snowmobile. I've heard a few people say you can break the ceramic heating plates easily. I would build the compartment for it pretty snug to help with it bouncing around, but just looking for info/suggestions. Thanks

Link to comment
Share on other sites

I routinely travel with my big buddy heater in the sled of my otter lodge. I have a Cabelas Big Buddy carry case that is padded plus I place 1.5" high density foam on the sides and bottom of the heater. Mine is tucked tight in the corner surrounded by milk crates which carry other things. I pull my otter lodge with a snowmobile for miles on LOW and Lake Winnipeg and have never had an issue.

I'm starting a new mod on my porty, and was wondering if anyone has had any issues keeping there buddy heaters in the sled while pulling behind a wheeler/snowmobile. I've heard a few people say you can break the ceramic heating plates easily. I would build the compartment for it pretty snug to help with it bouncing around, but just looking for info/suggestions. Thanks
Link to comment
Share on other sites

I've never had an issue with my big buddy laying in the sled of my Otter Lodge (something will break the next time I go to use it now that I say that) I usually have it surrounded by other stuff i have stored in there so it doesn't bounce around too much.

Link to comment
Share on other sites

I have not had the ceramic break, but I have broken off knobs, busted off the a handle or two, busted up the base or foot rods, and crushed the wire guard. Since then, I have had good luck with just putting the heater in one of those zippered carry cases.

Link to comment
Share on other sites

I built a box made out of particle board about 1/4" bigger all the way around and then put carpet on the inside so it don't have much room to move. Works great.

Link to comment
Share on other sites

Couple of years ago I had a broken ceramic plate, not sure if it was from bouncing in the sled or just a bad plate, its quite a job to replace them that I can tell you, lots of screws.

Link to comment
Share on other sites

  • 'we have more fun' FishingMN Creators

Couple of years ago I had a broken ceramic plate, not sure if it was from bouncing in the sled or just a bad plate, its quite a job to replace them that I can tell you, lots of screws.

I broke one too several years ago and replaced it and agree about the job of getting the new one in. Sure was a cold evening without a working heater though.

I now use the padded case and it's been good to go so far. Also help keeping snow out of the ceramic plates as the snow really makes it tougher to get them lit..

Link to comment
Share on other sites

Thanks for the info guys, only reason I ask is that a friend had one break, and agrees that it wasn't fun to replace. I plan on building the box pretty tight, and then using foam of some sort to keep it nice and snug in there. Good luck fishing all, and be safe on the ice

Link to comment
Share on other sites

Otherwise just buy some carpet and put inside the box you won't need much. I have found that a box with not much slop worked really well. Good luck

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



  • Your Responses - Share & Have Fun :)

    • gimruis
    • TenthousandLakes
      I must be real lucky, caught another healthy one, 30"  in the shallows tonight less than 6 FOW.    
    • leech~~
      Dude, I already trolled that spot, nothing but slimmers!  😄 Glad I saved money by stopping smoking a while ago. It's free most of the summer now! Been calm and yellow out for days! 🤧
    • leech~~
      Bet you would enjoy a nice paddle down the Cahulawassee River, too then. 😏
    • delcecchi
      Talked to my neighbor is getting ready for a trip via fall lake.    They use small boats with like 10 to 25 hp outboards and portage wheels.   There are two portages to get into pipestone bay, with the second one being over a hill.   From pipestone they can go around to Jackfish? bay,   There is a big sign to warn about where the no motors area is.    
    • Wanderer
      Don’t go!!!   I mean, that’s what they say anyway.
    • Kettle
    • leech~~
      Seems like a long way to climb, to sight in a gun! 😐
    • LakeofthewoodsMN
      On the South End... The walleye and sauger bite continues to be very good with anglers enjoying consistent action.  As we transition into fall, fish are being found at various depths, but 25 - 32 feet of water has been consistent. Jigging continues to pick up as the waters cool.  Water temps this week are down to 64.  Top jig colors this week include gold, orange, chartreuse, and pink.  For some anglers, big numbers caught this week jigging with frozen emerald shiners on the lake.   Some anglers are jigging on or adjacent to structure.  Others are finding schools of walleyes and saugers out over deep mud.  Using sonar to find fish is helpful.     Spinners and trolling crankbaits continue to produce fish as well.  This is a transition time where multiple presentations are working.  As the season progresses, jigging will take over as the top technique.     For those pulling spinners, gold, pink, orange, glow red, or glow white has been successful. Adjust your weights to 2 - 3 ounces to match the depth and speed you are drifting / trolling. Trolling crankbaits is still producing nice walleyes.  Some goto colors are gold, chrome / blue, pink UV firetiger, and chartreuse.     More and more walleyes are showing up along the south shore.  It seems things are gravitating towards fall patterns where good numbers of the fish are both chasing shiners and moving closer to shorelines.  The bite has been excellent and is really shaping up nicely for the fall jig bite both on the lake and in the Rainy River. On the Rainy River... A variety of species continue to be caught on the Rainy River.  Nice current flow is providing fall anglers some optimism for this year's fall shiner and walleye run being a banner year.  Some reports of nice walleyes being caught in the river already this week.   There are reports of shiners in the river all the way up to Birchdale.  Things seem to be setting up nice for a great fall on the river.  Mother Nature will have the final say of course. Sturgeon fishing is picking up with cooling waters.  Anglers anchor up and use a combination of crawlers and frozen emerald shiners on a sturgeon rig with a flat no roll sinker.     Find a hole in the river or simply mark these big fish in an area, anchor up and soak some crawlers! Up at the NW Angle... Walleye fishing up at the NW Angle remains really good. Fish are being found in many areas.  Structure, neck down areas as well as on the flats.   Some good fish are still holding in the deep mud east and northeast of Little Oak Island in the mud.  Areas around Four Blocks, and north of Garden Island producing fish as well.    As on the south end, jigging, spinners / crawlers and trolling crankbaits are all producing walleyes.   Smallmouth bass, pike and muskies are also being caught, both by unsuspecting walleye anglers and when targeted.  As the waters cool, crappies and jumbo perch are also showing up nicely for anglers.    
    • Kettle
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use and Privacy Policy. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.