Guests - If You want access to member only forums on FM. You will gain access only when you Sign-in or Sign-Up on Fishing Minnesota.

It's easy - LOOK UPPER right menu.

Sign in to follow this  
Followers 0
Blufinn

Trolling motor problems

2 posts in this topic

I have a pinpoint 3700 24 volt and I hooked it up and all I get is lines on the display and nothing else works it does turn on and beeps but thats it, it has 2 wires a orange and white since I have no manual I hooked it up positve to orange and negative to white and also the plug has 4 pins but I can only see using two of them I did check voltage and I have 24 volts any suggestions? Thanks!

Share this post


Link to post
Share on other sites

I had a similar problem with a different motor, it turned out to be that the two batteries that I was using, wern't putting out enough voltage. I had one new battery and one old battery. I bought two new batteries, and an onboard charger. After that the problem went away. If you test the batteries you should get a little better than 13 volts out of each battery.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  
Followers 0