Guests - If You want access to member only forums on FM. You will gain access only when you Sign-in or Sign-Up on Fishing Minnesota.

It's easy - LOOK UPPER right menu.

Sign in to follow this  
Followers 0
tcroz

Replacing Bilge Pump

3 posts in this topic

Bilge pump went out in my 2004 Lund 1800 tiller

(A little early I thought) what kind of job is it to replace? Anyone have any advice as which type to buy?

Any advice would be appreciated!!

Share this post


Link to post
Share on other sites

On some of the newer models, the pump just snaps into the base that is mounted in the boat. Not a hard job to do once you get a look at how things are mounted.

Share this post


Link to post
Share on other sites

There should be a round snap on cove in the middle of your splashwell, pry it or twist it open, you will see your pumps below.

Be sure your fuses are good before replacing it.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  
Followers 0