Guests - If You want access to member only forums on FM. You will gain access only when you Sign-in or Sign-Up on Fishing Minnesota.

It's easy - LOOK UPPER right menu.

Sign in to follow this  
Followers 0
basskiller

boat landing?

3 posts in this topic

Just wondering if anyone would happen to have directions to that landing south of kellogg i"ve been hearing about? Any reply would be awesome! wink.gif

Share this post


Link to post
Share on other sites

R you looking for the west neuton landing??? if so i beleive directions for it can be obtained off of the dnr website. good luck. ike

Share this post


Link to post
Share on other sites

I have not been down there yet but I asked my sisters boy friend about it, who was going to fish it Wednesday and he didn't think there was much water in that backwater area. He told me it would be a safer bet to land at Alma. My dad lives on the river just above the dam on the Mn. side. He went over ane the Alma landing is good. No Ice. Said the locks were open and the water dirting up.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  
Followers 0



  • Posts

    • ZachD
      Those are quantom blades in that picture and they work great for reopening holes and I never had a problem with it being bad for the blades in fact that ring around the bit on the bottom is to help guide the blade when going through a preexisting hole
    • Cliff Wagenbach
      When I fished Trout Lake a lot live Light Northers Suckers under a tip-up would out catch Ciscos every day of the week!
    • mrklean
      Last I heard no plowed roads yet
    • wahoo
      Mine looks like that.  And it does reopen holes, and is sharp.  But, had read in past it was not good for the blade.  A friend indeed has attached a 10" Strikemaster, dual blade to his Eskimo so it does work.  His impressively cuts holes quickly, at angles, etc.  He spears so he does 5 holes side by side , 3 holes deep, then augers side ways to remove in between.  Works well.  Complete hole done, less scooping, in under 10 minutes.   Thanks for all the advice.  Could use something larger than 8" anyway, so may go to 10.  Also will redo back part by toy hauler door, under bunks to a 20" x 5' hole, covered and hinged of course.  May spear, but even if not I love watching the fish and various movements of bait, etc.   Again, thanks for being generous. Wahoo
    • huntzy42
      I am looking for a lake that produces large gills/crappies  Can anyone suggest a Lake in MN that I can hit?